PG SFA Flashing is higher viscosity version of our solvent-free adhesive for modified bitumen systems. It is specifically engineered to be used with Polyglass SBS membranes.
PG SFA – solvent free adhesive, is a proprietary hybrid polymer adhesive specifically engineered to serve as a cold-applied bonding agent. A single component, moisture cure adhesive, it is designed for secure attachment of SBS (Styrene-Butadiene-Styrene) modified bitumen base sheets as well as SBS modified bitumen cap sheets, whether smooth or granulated, ensuring strong adhesion without the need for heat or open flames. As part of the PG adhesive product line, it is specifically tailored for markets and regions where strict environmental regulations are in place, focusing on minimizing VOC emissions to comply with building codes.
Polyglass Polystrip SA is a self-adhering waterproofing tape composed of a slip resistant surface and UV resistant film laminated to an aggressive elastomeric (SBS) modified asphalt adhesive. The adhesive is protected by a siliconized release paper which allows quick and accurate installation.
Polystrip SA seals the roof deck seams and other construction details in compliance with project and/or building code requirements where a self-adhesive strip meeting ASTM D1970 standards is designated.
Polystrip SA may be covered with any Polystick or Polyanchor roofing underlayment or roofing felt. Polystrip SA can also be used as a general flashing membrane.
Designed to help roofing professionals estimate how many rolls of Polystrip SA joint tape are needed based on the square footage of a roof. Estimates are based on standard measurements for plywood and joint spacing to calculate the total linear footage of deck joints and provide an accurate roll count.
| Roll | Width | Length | Rolls x box | Coverage x box |
|---|---|---|---|---|
| 4″ Wide | 4″ (10.2 cm) | 67′ (20.4 m) | 12 | 804′ (245 m) |
| 6″ Wide | 6″ (15.2 cm) | 67′ (20.4 m) | 8 | 536′ (163 m) |
PG 350 LV is a low-VOC (Volatile Organic Compound) adhesive specifically engineered to serve as a cold-applied bonding agent. It is designed for secure attachment of SBS (StyreneButadiene-Styrene) modified bitumen base sheets as well as SBS modified bitumen cap sheets, whether smooth or granulated, ensuring strong adhesion without the need for heat or open flames. As part of the PG adhesive product line, PG 350 LV is designed for markets that emphasize sustainability and lower environmental impact.
Vertiwrap VPL and VPL LT air barrier membranes permit the passage of water vapor, while acting as a barrier to air and liquid water. Vertiwrap VPL and VPL LT reduce the build up
of moisture in the wall assembly, increasing the wall durability and comfort of the building occupants. Vertiwrap VPL and VPL LT are compliant in a wide variety of NFPA285 wall
assemblies.
PRE-APPLIED, FULLY BONDED WATERPROOFING MEMBRANE WITH MULTI-LAYER TECHNOLOGY FOR BELOW GRADE APPLICATIONS
Mapeproof FBH is a fully bonded membrane for foundation waterproofing. It features an HDPE layer with multi-layer bonding technology, ensuring both adhesive and physical bonds with concrete. The PolyPropylene fibers enhance mechanical interlocking during the initial concrete curing process, reducing delamination risk when the concrete forms are removed. The unique fiber pattern increases bonding surface area, while SEALLap® Technology reinforces side laps for better adhesion. At 49 mils thick, it withstands foot and trade traffic, offering high durability. HDPE provides excellent resistance
to contaminants like methane and radon. Mapeproof FBH is easy to use for both horizontal and vertical applications, with a kick-out roll design for quick installation. It’s also Red List free, making it an environmentally friendly choice.
Features and benefits